SPECIFICATIONS:
Model: B-2000
POWER
Power Requirements: AC220V 10%, 50Hz 2%
Power Input: ≤450VA
Refer to IEC60601-1, this equipment belongs to Class I, Type B. Its operation is Continuous.
ALARM
Power Alarm
Power Failure: Activates if primary power to the Incubator
Fails or the power wire is accidentally
Disconnected from the wall receptacle.

Fan Alarm
Fan Failure: Activates if Fan motor malfunctions. Sensor Alarm
Air Sensor Failure: Air Sensor malfunction, refer unit to service.
Sensor Out of Position: Activated when Sensor is not in correct position To perform calibration or continue operation.
Skin Sensor Disconnected: Activated during Skin Control Mode when Skin Sensor is disconnected from Temperature Controller. Skin Sensor Failure: Activated when Skin Sensor malfunctions.
Deviation Alarm High Air Temperature: Activated if displayed Air Temperature is 1.5 centigrade above set point
Low Air Temperature: Activated if displayed Air Temperature 2.5centigrade below set point

Skin Temperature: Activated if displayed Skin Temperature is 1.0 centigrade above set point
Low Skin Temperature: Activated if displayed Skin Temperature is 1.0Over Temperature Alarm
Over Air Temperature: Activated when displayed Air TemperatureWas approach 38centigrade for set temperature ≤37centigrade, Or approach 40centigrade for set temperature >37centigrade in Air Mode.

Over Skin Temperature: Activated when displayed Skin Temperature was approach 38centigrade for set temperature ≤37centigrade, Or approach 39centigrade for set temperature >37centigrade in Skin Mode. System Alarm
System Failure: Activated if Temperature Control System malfunctions.

TEMPERATURE CONTROLRANGEAND CORRELATIVE SPECIFICATIONS
Air Temperature: 20centigrade ~37centigrade, for set temperature ≤37centigrade
37centigrade ~39centigrade, for set temperature >37centigrade
Skin Temperature: 20centigrade ~37centigrade, for set temperature ≤37centigrade
37centigrade~38centigrade, for set temperature >37centigrade
Temperature Rise Time: ≤30min
Temperature Variability: 0.5centigrade
Temperature Uniformity: ≤ 1 centigrade
Skin Sensor Precision: ≤0.3centigrade
ENVIRONMENT REQUIREMENT

Environment Temperature
Operation Temperature Range+20centigrade ~+30centigrade
Store Temperature Range -40centigrade ~+70centigrade
Environment Humidity
Operation Humidity Range: 30%~75%
Store Humidity Range: ≤80%
Atmospheric Pressure Range: 500hPa~1060hPa
OTHER SPECIFICATION
Noise Level Within Hood Environment ≤55dB(Environment noise below 45dB Carbon Dioxide (CO2) Level within the Hood Less than 0.5% when a mixture of CO2

In air is delivered at 750ml/min
At point 10cm above the center of the mattress.
Air Velocit y Over Mattress less than: 0.35m/s
Infant Bed Max Load: 10kg
Transfusion Shelf Max Load: 2kg
Shelf Max Load:
Cabinet Max Load: 6kg

BNT-2000B Infant Radiant Warmer

STANDARD COMPOSITION

●Temperature Control Mode: pre-heating control, servo control & manual control;
● Instant Parameter Display: set temp, skin temp, heat power rate;
● Built-in APGAR Timer and >37℃ preset function
● Audible/Visual Alarms: temp deviation, sensor failure, power failure, temp override;
● Tilting Bed with Rotary Radiant Head;
● X-ray Cassette Tray under infant bed, examination light of high illuminance;
● Use anti-blast quartz infrared tube as radiant heating source;
● With phototherapy unit;
● With two oxygen cylinders;
● With Suction, with neonate resuscitation.

BNT-2000B Infant Radiant Warmer

STANDARD COMPOSITION

●Temperature Control Mode: pre-heating control, servo control & manual control;
● Instant Parameter Display: set temp, skin temp, heat power rate;
● Built-in APGAR Timer and >37℃ preset function
● Audible/Visual Alarms: temp deviation, sensor failure, power failure, temp override;
● Tilting Bed with Rotary Radiant Head;
● X-ray Cassette Tray under infant bed, examination light of high illuminance;
● Use anti-blast quartz infrared tube as radiant heating source;
● With phototherapy unit;
● With two oxygen cylinders;
● With Suction, with neonate resuscitation.

B-400 Infant Phototherapy Unit

STANDARD COMPOSITION:

 Use LED light as lighting source, LED digital timer, display therapy time & total time

TECHNICAL SPECIFICATION:

POWER
Model B-400-1E.........................................................................110 / 120 Vac, 50Hz / 60Hz
Model B-400-2E................................................................................220 / 240Vac, 50Hz / 60Hz
Input power...............................................................................................................≤50VA
Accord with IEC 60601-1 standard, this device is in class I, continuous handling.
Ebi in effective area surface.....................................................................................500μW/cm2
Ebi max in effective area surface..............................................................................650μW/cm2
Ebi average in effective area surface...................................................................................500μW/cm2
Uniformity of Ebi...............................................................>0.4　　　　　　　　　　
Infrared radiation in effective area....................................<1mW/cm2(760nm<λ≤1400nm=
Ultraviolet radiation in effective area................<1.0×10-5mW/cm2 (180nm<λ≤400nm=
Time display accuracy............................................................................................2h±1min
Operate noise........................................≤50dB(A)（ambit noise is lower than 40dB(A)）
ENVIRONMENT CONDITION
Environment temperature
Operate temperature

B-400 Infant Phototherapy Unit

STANDARD COMPOSITION:

 Use LED light as lighting source, LED digital timer, display therapy time & total time

TECHNICAL SPECIFICATION:

POWER
Model B-400-1E.........................................................................110 / 120 Vac, 50Hz / 60Hz
Model B-400-2E................................................................................220 / 240Vac, 50Hz / 60Hz
Input power...............................................................................................................≤50VA
Accord with IEC 60601-1 standard, this device is in class I, continuous handling.
Ebi in effective area surface.....................................................................................500μW/cm2
Ebi max in effective area surface..............................................................................650μW/cm2
Ebi average in effective area surface...................................................................................500μW/cm2
Uniformity of Ebi...............................................................>0.4　　　　　　　　　　
Infrared radiation in effective area....................................<1mW/cm2(760nm<λ≤1400nm=
Ultraviolet radiation in effective area................<1.0×10-5mW/cm2 (180nm<λ≤400nm=
Time display accuracy............................................................................................2h±1min
Operate noise........................................≤50dB(A)（ambit noise is lower than 40dB(A)）
ENVIRONMENT CONDITION
Environment temperature
Operate temperature

STANDARD COMPOSITION:
● Single-side & five blue lights
● LED Digital Timer, display therapy time & total time
● Lifting & Mobile Stand, radiant head rotating by angle of 30°/ 60° /90°

STANDARD COMPOSITION:
● Single-side & five blue lights
● LED Digital Timer, display therapy time & total time
● Lifting & Mobile Stand, radiant head rotating by angle of 30°/ 60° /90°

STANDARD COMPOSITION:
● Single-side & LED lights;
● LED Digital Timer, display therapy time & total time;
● Top-put type applicable for any model of incubator.
 

STANDARD COMPOSITION:
● Single-side & LED lights;
● LED Digital Timer, display therapy time & total time;
● Top-put type applicable for any model of incubator.
 

STANDARD COMPOSITION:
● Servo Control Mode: air temp;
● Instant Parameter Displaying: set temp, air temp, heat power rate;
● Audible & Visual Alarms: power failure, sensor failure, higher/lower temp, air temperature override, fan failure;
● Power failure reset memory and self-test function;
● Hood with dual slope: 4 hand-ports.